Maintenance & Technical > KX500 Original

foot peg mounts

(1/1)

mikesmith:
Any one use Terry Cable or Pro Circuit foot peg mounts.If so are they a lot stronger than stock.I noticed my peg was getting sloppy,had about 1/4" play were the mounts bracket had spread.

KX142:
I bent the mount on mine and got the tery cable mount to replace it. it looks a lot stronger, but the pin isn't long enough for the cotter pin to go in so I had to drill a new hole in it. Haven't bent this one yet!

Greenrider:
Terry Cable has two different fixes for this problem. First is a kit with oversized pins and a drill bit. You drill out the stock peg mounts and install the oversized pins to tighten things up. Second is a bullet proof left side peg mound that is much stronger than stock, both are excellant products!

Navigation

[0] Message Index