Maintenance & Technical > KX500 Original
Needle ?
Foxx4Beaver:
--- Quote from: reklessj on September 29, 2015, 01:37:48 PM ---Thanks Foxx your on it!!! Trying to jet this thing perfect!!!!
--- End quote ---
when I was running my stock carb, I had a rich spot down low that I couldn't get rid of by just jet changes...I got a #8 slide, and all my rich issues went away.
I was running the N82T in the second from top...
52 pilot...
168 main...
#8 slide...
1 3/4 out with the air screw
I run between 100'-250' elevation...these settings were very close to being devastatingly lean if I were to be doing extended periods of WOT.
I run the #8 slide in my new carb now, along with the "T" needle.
sandblaster:
If it was about 150 deg F out I could probably run those numbers :-D
reklessj:
--- Quote from: sandblaster on September 30, 2015, 01:26:52 PM ---If it was about 150 deg F out I could probably run those numbers :-D
--- End quote ---
My #'s or Foxx's?
reklessj:
So I got about 20 minutes around the yard , I put the R needle in(center clip position) left the 60P, 170M in and air screw 2 turns out. Cleaned up quite a bit but not quite there yet but much better
sandblaster:
--- Quote from: reklessj on September 30, 2015, 01:36:31 PM ---
--- Quote from: sandblaster on September 30, 2015, 01:26:52 PM ---If it was about 150 deg F out I could probably run those numbers :-D
--- End quote ---
My #'s or Foxx's?
--- End quote ---
Fox's..
Different kind of riding.
Mine is a lot more WOT!!!
Not many trees or rocks in the way..
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version