Maintenance & Technical > KX500 Original

how to i check the power valves

<< < (8/9) > >>

sandblaster:
 8-)

alexander-vmann:
i got in the reed cage and set to change the float valve, i checked the float heigth with the new valve and old, the old was 11mm the new about 15-16mm, then i filled up the coolant and noticed a leak from the water pump cover(https://www.youtube.com/watch?v=Tl3euCXhpaQ) and the kill switch stopped working (https://www.youtube.com/watch?v=Tl3euCXhpaQ) BUT the engine started second kick and the valves open and close, it's probably running rich thouhg so i still have some work to do :roll:

alexander-vmann:
here is the proof, thanks for the help guys! https://www.youtube.com/watch?v=CkfjSO_1Yhw

dave916:

--- Quote from: alexander-vmann on December 13, 2015, 05:45:13 AM ---tried timing the valves today, they're open at the same time but one closes more then the other  :?

closed


open


--- End quote ---

You need to fix the over closing kipps valves , that the reason they are wrong on the closed position

alexander-vmann:

--- Quote from: dave916 on January 16, 2016, 06:43:50 AM ---
--- Quote from: alexander-vmann on December 13, 2015, 05:45:13 AM ---tried timing the valves today, they're open at the same time but one closes more then the other  :?

closed


open


--- End quote ---

You need to fix the over closing kipps valves , that the reason they are wrong on the closed position

--- End quote ---
how do you suggest i do that? i dont think i can just put them in a diffrent grove on the valve rod

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version