Maintenance & Technical > KX500 Original

Tank brass thread insert

<< < (2/2)

b4himdude:
as long asyou are talking about the inserts that you use to bolt the shrouds on i have an alternative to melting away the tank. i cut me off a bolt that fits inside the brass threaded insert and mixed me up a nice batch of jb weld put the nub of the bolt into the insert that just spins and spins so that it stuck out far enough to get through the shroud and let it cure real good. now it works just the same but instead of putting the bolt on i just put the nut on the bolt. and the brass piece doesnt move at all now. problem solved.and whoever reads this are the only ones that would know even by looking you cant tell the difference

Swe_K5_89:
That was another way to solve the problem. Will consider that if I can't find a insert. Thanks!

Navigation

[0] Message Index

[*] Previous page