Maintenance & Technical > KX500 Original
Mint 02 500 Setting up for moto!
edgar_kx3:
--- Quote from: sandblaster on June 26, 2015, 03:26:10 PM ---Besides what all has been mentioned... get some dog bones from Emig.
It will help your turning on the mx track.
And get your suspension dialed in..... Nothing else will make you faster.
Then get your head cut and double check your jetting to help with bad fuel.
--- End quote ---
Thanks, and yes the dog bones are getting ordered next week. Ive played around alot with the jetting its really good now as long as I mix 50/50 110 race fuel with super. I think im going to go ahead and start running straight 110 when I start riding it again.
sandblaster:
I run 92 non ethanol and no pinging :-o
edgar_kx3:
--- Quote from: sandblaster on June 27, 2015, 03:35:41 AM ---I run 92 non ethanol and no pinging :-o
--- End quote ---
Off subject but when you used a 450 rear wheel you said in a post that you need to take 20mm off the rotor. Is that on total diameter? 10mm per side correct?
sandblaster:
Alward25 made that comment...
I'd PM him.
But 20mm overall or 10mm per side sounds right.
alward25:
I did not post any dimentions, I just buy the custom one from Warp 9 and get the wheel spacers from them too to run the kx 450 rear wheel.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version