Maintenance & Technical > KX500 Original

Spur Gear Bearing help? W/picture

(1/1)

budryzer:
Greetings All,
   I have a manual and I used the search feature but I'm in need of a link.  Milky Oil, so I checked and found this groove in my spur gear shaft.  I ordered two new bearings, shaft and seals.  My question is my manual doesn't show this '93 type of install.  Do I install the bearings in the case and then press in the spur gear?  It appears that my existing spur gear is a tolerance fit.....   Also, I should have two seals and two bearings, correct?
Any link to a thread on this would be helpful to me.

Thanks

budryzer:
Well, I got the seal.  It's just one wide seal, that is open on each side to keep one fluid away from the other.  They don't play well together :-o
Bearings and spur should arrive this PM in the mail.

My mailman shows up after 5pm here.......

dave916:
Marking {writing] on seals towards the bearings
Make sure to grease seal lipps

budryzer:
Yup, Thanks.  Just put it in.  New spur and bearings as well.  Should put the bike back together tomorrow:)

Navigation

[0] Message Index