Maintenance & Technical > KX500 Original
first k5 very well used. need some advice
sandblaster:
Stock reed with a stock engine I run the stops.
V-Force 2's have no stops so run them as is on high tension setting for higher top end and low tension setting for better bottom end response.
I have no idea what others are doing..
Foxx4Beaver:
--- Quote from: sandblaster on October 01, 2014, 05:11:07 AM ---V-Force 2's on high tension for top end.
I have no idea what others are doing..
--- End quote ---
high
younGun:
i have the boyesen carbon ones. they seem great they just chatter at low rpm so i was concerned. only my second 2T last one was a 85. what gearing do you guys usually run? whats on this bike is wayyyyy higher than anything I've dealt with. i don't even use 5th gear...... top end for dayyyyyz! love this bike! so much power.... yet such a nice seat?
sandblaster:
Boyesen's are good for low end power.
I would replace the pedals as they do wear out.
My gearing?
To the moon baby :lol:
idaho_nate:
I have an XR that I put a JB Waterweld patch on and it has been leak free for a couple of years. It's even at the bottom near the petcock and has held up ok so far.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version