Maintenance & Technical > KX500 Original
90 kx 500
Rougedante:
Know where to buy a valve kit at to have a local machine shop do it
Rougedante:
http://buggynews.com/post453141.html#p453141
Pictures of the cyl...
Rougedante:
Cylinder looks sleeved and I believe I have the vf2 reeds already. Pictures further down the page on tht link
Pmcg:
--- Quote from: Rougedante on October 09, 2014, 09:31:29 AM ---Know where to buy a valve kit at to have a local machine shop do it
--- End quote ---
I am sure you could accomplish the same thing Larry's doing but I'm not sure how much cheaper you could get it done and I must say that his welding is on another level. You can't tell the valve isn't stock.
Rougedante:
I did contact him. I decided to go with him. My cylinder is sleeved so I can just get it bored over to the next size piston. And I already have vf2 reeds.
So I guess ill have larry do his mods get it ported and bored to the next size and call it all good and put it back together
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version