Maintenance & Technical > KX500 Original
1985 Kick Start Idle Gear
motojason:
--- Quote from: sandblaster on April 29, 2014, 06:27:16 AM ---You are correct, they have 26T all the way to 04.
I do have a few newer parts in my junk piles and could get you some measurements.
If you take measurements of what you need and make a small diagram showing what you have measured, I could get some comparison measurements.
--- End quote ---
Let me know if you have any questions. Appreciate the help!
sandblaster:
I'll be very busy on Monday so I may not be able to get the measurements until Tuesday.
motojason:
Great, thanks! I'll check back in mid-week.
sandblaster:
I would measure your clutch basket as well as the spacing between the kick idler shaft and the clutch trans shaft..
motojason:
Thank you! There is quite a bit of difference in thickness. I will take some more measurements. Given the near 4mm difference in tooth width I am concerned that even if the shaft centers, and diameters align with the 86+ parts that the offsets and cover clearances might not work out.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version