Maintenance & Technical > KX500 Original

kx500 tripple clamps,...where are they at?

<< < (9/9)

husky333:
I got my kx500 EMIG tripple clamps, but need to buy a bearing kit for them. Is it the stock size bearing kit i need? The stem has been supplied by EMIG, i am guessing that they use the standard kx500 size stem, is that correct?

motopunk:

--- Quote from: husky333 on March 23, 2014, 07:02:29 PM ---I got my kx500 EMIG tripple clamps, but need to buy a bearing kit for them. Is it the stock size bearing kit i need? The stem has been supplied by EMIG, i am guessing that they use the standard kx500 size stem, is that correct?

--- End quote ---



all you could do is measure both stems and then for the case, that it is diferent, you could look for german SKF - bearings .. there is a wide range of bearing sizes that you could use with same outer diameter and many diferent inner diameters...

Navigation

[0] Message Index

[*] Previous page