Maintenance & Technical > KX500 Original

Photo Gallery.

<< < (6/14) > >>

hughes:
Machine,

Look in my gallery and check out my reed block spacer I machined this week. It took acouple hours but it was fun watching the chips fly. :D

machine:
Looks great!!
What type of machine did you make it on????

hughes:
Bridge Port with digital read out. I might go back and use a finishing bit for the inside of the spacer. There are some tool marks. But they dodn't hart anything. I won't mind some under table cash if you were on the east coast. One thing is for sure I can not weld worth a d*mn.

machine:
Yea!!!!!!!! The good old Bridgeport!!!
Very good!

I do pretty much all CNC wrok.
I do have a Bridgeport too. good machines!!!!
Great job!
Don't you want a rough inside, to atomize the fuel????

crazyryan:
This is my first time at this site.  I own and race a super trick KX500.  How does this site work?

Navigation

[0] Message Index

[#] Next page

[*] Previous page