Maintenance & Technical > KX500 Original
2000 KX500 Project
Pmcg:
sounds good I think I'll spend a bit more time lapping the cases then. I did order all new c clips thanks. Any ideas on the lower clutch release bearing?
sandblaster:
Don't know any one that makes them long enough :cry:
You can make your own or you can drill a small hole underneath the bearing and use a punch to drive it out.
Then tig the hole..
alward25:
--- Quote from: sandblaster on September 18, 2013, 03:42:57 PM ---Don't know any one that makes them long enough :cry:
You can make your own or you can drill a small hole underneath the bearing and use a punch to drive it out.
Then tig the hole..
--- End quote ---
I have one :-D :-D :-D Maybe I could start a loaner program??
sandblaster:
When you come down next time... please bring it..
I'm in no hurry but I could use it...
Oh, and Christmas Valley this weekend.. :-D
Pmcg:
--- Quote from: alward25 on September 18, 2013, 03:53:21 PM ---
--- Quote from: sandblaster on September 18, 2013, 03:42:57 PM ---Don't know any one that makes them long enough :cry:
You can make your own or you can drill a small hole underneath the bearing and use a punch to drive it out.
Then tig the hole..
--- End quote ---
I have one :-D :-D :-D Maybe I could start a loaner program??
--- End quote ---
If you wouldn't mind I would be happy to pay shipping. I think I should need it for all of 30 seconds.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version