Maintenance & Technical > KX500 Original
2000 KX500 Project
don46:
Like I said to each his own use what you like, There is a difference, nuff said.
There is a shaft going down the center of the puller to expand the cuts at the bottom
lower clutch arm bearing
Motorrad:
My cases are actually put together with hylomar AND a silk thread if you want to be totally anal like I tend to get
sandblaster:
Here's another pic of Don's blind bearing puller showing the difference in the usable length
alward25:
One of my pullers, works slick on the bearings and don't have to take the engine out....
sandblaster:
Nice.
I guess I will have to make one as well :-)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version