Maintenance & Technical > KX500 Original

2000 KX500 Project

<< < (8/55) > >>

sandblaster:
Send me a pic and I will post it
oem-cycle@comcast.net

sandblaster:


The upper pic is a standard puller.
The bottom pic is the one Don made.

Thanks for sharing.

Motorrad:
which bearing are we talking about?


I too think the yama and 3bond are same thing.


I use only the yamabond... due to the better "applicator tip"... and its impervious to gas.


no sillycone for me  read the link to find out why...  

http://www.devcon.com/prodfiles/pdfs/fam_tds_373.pdf

Pmcg:

--- Quote from: Motorrad on August 05, 2013, 03:16:37 PM ---which bearing are we talking about?

--- End quote ---

The lower roller bearing for the clutch release arm.

Thanks for the picture don I was toying with the idea of trying to make something myself on my really old screw making lathe. I was even thinking about just running the shoulder off if my smallest blind hole puller. 

alward25:
From the Yamalube site-

       
< Return to All Adhesives Products
Yamabond® 4 Motorsports
A silicone-based liquid gasket that fills gaps on a flange surfaces, when cured (sets in 60 minutes), this product forms a rubber-like gasket that resists high temperatures and seals joints, gear- and engine-oil resistant, Use where the service manual specifies "Threebond 1215"

still a silicon :wink:

Navigation

[0] Message Index

[#] Next page

[*] Previous page