Maintenance & Technical > KX500 Original
2000 KX500 Project
Pmcg:
I didn't realize you finished the motor rebuild, or did you have 2? I know you replaced bearing on 1 of the motors and had it blasted if I rember. Did you replace the clutch release bearings?
sandblaster:
Oh that motor :lol:
Nope still toying with that one and I will be replacing the lower bearing.
That motor is going to be fear inspiring :lol:
Pmcg:
Can't wait to see it. What are your plans? How did you get those release bearing out?
sandblaster:
I will drill the bottom out as my blind bearing puller won't get to it :cry:
Plans?
Porting, timing, windowed Wossner, balanced, head, Motorrad mods, reed, pipe, MZB ignition, and whatever else :-)
Pmcg:
Ok bearings are ordered. I plan on ordering loctite 648 for the bearings and know I need yamabond for the cases and seals but am not sure what number To order. Any suggestions?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version