Maintenance & Technical > KX500 Original
2000 KX500 Project
dave916:
Sounds like could be a bit of fuel pipe [rubber] stuck behind float needle valve {remove the valve and clean out circuit and be careful fitting the petrol pipes as little bits can cause this when fitting
Can never understand how old floats need adjustment [unless everthing in there is worn out
I would double check for air leaks and carb slide
LukeG:
I bought mine from Motosportz. Kelly had a lot of write ups out there and I figured what the heck!
Pmcg:
Thanks Luke. Did you go with the 44mm? How do you like it?
Pmcg:
I ended up calling Packard and the guys over there were great. Very patient and answered all of my questions. Best part is they have the 44 in stock and it will ship today. Now I'm just hoping that I didn't do any damage when she revved to the moon.
sandblaster:
44mm?
Huge!
Get it all set up then give me your specs so I can do mine 8-)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version