Maintenance & Technical > KX500 Original
2000 KX500 Project
alward25:
New boots looked cracked, not sure of their process, not the smoothest, as long as you can't see any cracks on the inside. Good to go
Pmcg:
Any advice on removing the power valve bearing from the clutch cover? My puller is to big (I don't run into that issue often) and I had 1 made smaller but it just bent.
sandblaster:
Heat and a blind bearing puller gets 99.99% of them out.
Pmcg:
So my new issue is that the oversized Clarke tank hits my compression release valve. I'm considering heating and bending the tank around the release but terrified of ruining my new tank. Anyone have advice on bending? I'm also considering trying to trade for a tank that will fit but am not sure what oversized tanks work.
Pmcg:
So heat gun and a pipe?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version