Maintenance & Technical > KX500 Original
Project "I needed to clean the air filter so I blew the motor"
sandblaster:
--- Quote from: Motorrad on September 09, 2013, 02:52:41 AM ---
--- Quote from: sandblaster on September 09, 2013, 02:33:53 AM ---
--- Quote from: Motorrad on September 09, 2013, 01:40:05 AM ---I was given a copy of the Socal timing association (bonneville and el mirage) rules yesterday.
Uh OH.
--- End quote ---
You better.
I'd love to see another member walk away with a new land speed record.
And, if you need a test pilot I'm available....
Getting to old to hold it wide open over the rough stuff for very long but I have no problem with high speed wobbles on the smooth stuff :-D
--- End quote ---
if I did go for the record. Id pull a horse racing move. and put a 105lb guy on it.
--- End quote ---
So I'd only have to loose 115 lb?
SWEET!
USMC 500:
--- Quote from: Motorrad on September 09, 2013, 02:52:41 AM ---
--- Quote from: sandblaster on September 09, 2013, 02:33:53 AM ---
--- Quote from: Motorrad on September 09, 2013, 01:40:05 AM ---I was given a copy of the Socal timing association (bonneville and el mirage) rules yesterday.
Uh OH.
--- End quote ---
You better.
I'd love to see another member walk away with a new land speed record.
And, if you need a test pilot I'm available....
Getting to old to hold it wide open over the rough stuff for very long but I have no problem with high speed wobbles on the smooth stuff :-D
--- End quote ---
if I did go for the record. Id pull a horse racing move. and put a 105lb guy on it.
--- End quote ---
Allyn knows how to ride right?? :wink:
81cr450:
--- Quote from: Motorrad on September 09, 2013, 01:40:49 AM ---
--- Quote from: 81cr450 on September 08, 2013, 10:34:07 AM ---Yeah I tried stealing one off google. :roll:
Theyre 4 stroke pistons for gas motors, but ... theyve moved the skirt support inward right to where your slicing the linear window.
Ummm stolen image? :evil:
Having the support there makes the piston strong enough you can make a 4.350 bore bbc piston weigh 740 grams which is sbc stock piston weight, point being theres gotta be alot of load going on in that area of the piston.
--- End quote ---
I like the skirt bracing. but the deletion of the side skirts on the K5 motor would cause PROBLEMS
--- End quote ---
Just structural integrity was all I was looking at, as far as where you had the linear ports marked, the exact location modern pistons carry their load.
I'm already in utah, & only weigh 167 :-D
sandblaster:
And, what's the deal?
New cylinder?
New 6 windowed piston?
Ceramic bearings?
Liquid hydrogen and liquid oxygen mixing chambers?
High-power impulse magnetron sputtering coated cooling system?
We gotta know.... :-o
alward25:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version