Maintenance & Technical > KX500 Original

Cometic Gaskets

<< < (3/5) > >>

Bigtim:
i posted a few years back about a cometic kit that had the stud holes for the base basket in the wrong positions.  I prefer the Kawi base gaskets over anything else. I don't like the paper gaskets, had 1 too many blow out on a ride.  Otherwise, no complaints.

Motorrad:

--- Quote from: Bigtim on May 02, 2013, 09:47:50 AM ---i posted a few years back about a cometic kit that had the stud holes for the base basket in the wrong positions.  I prefer the Kawi base gaskets over anything else. I don't like the paper gaskets, had 1 too many blow out on a ride.  Otherwise, no complaints.

--- End quote ---

cometic gaskets arnt paper.    athena ones are..    :?

sandblaster:
Yep, the only top end gaskets I sell are Cometic.
I sell a lot of them and never had a failure due to a bad gasket.
In every case where a customer complained (Not many) it was always improper installation or bad mating surfaces.

cbrfrenzie:

--- Quote from: Motorrad on May 02, 2013, 09:56:10 AM ---
--- Quote from: Bigtim on May 02, 2013, 09:47:50 AM ---i posted a few years back about a cometic kit that had the stud holes for the base basket in the wrong positions.  I prefer the Kawi base gaskets over anything else. I don't like the paper gaskets, had 1 too many blow out on a ride.  Otherwise, no complaints.

--- End quote ---

cometic gaskets arnt paper.    athena ones are..    :?

--- End quote ---

I believe Cometic has a part number for a standard paper base gasket (or at least a NON AFM gasket) PN: B0036012F http://www.shopengineparts.com/productdetails.aspx?emid=782&cid=127&pid=10864&vtype=Dirt&make=Kawasaki&model=KX500+E3%2c+T2%2c+R2+-+%2891-04%29&type=model

Not sure why anyone would order this.... the one in the "kits" are the AFM gaskets (PN: B0036018AFM) here: http://www.shopengineparts.com/productdetails.aspx?emid=782&cid=127&pid=10862&vtype=Dirt&make=Kawasaki&model=KX500+E3%2c+T2%2c+R2+-+%2891-04%29&type=model

Maybe this will clear things up a little bit?   :-P

alward25:
You can get the gaskets cut out of whatever material u want

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version