Maintenance & Technical > KX500 Original
KX500 AF Running like a 200
RKPerformance:
No I welded the kx500 mouth (cylinder mount) on the cr500 pipe. But things just dont seem to line up at all and dont fit where they are supposed to. s**t hits the left radiator and waterpump side is no where near close to clearing the cylinder etc. Im lost when it comes to this unless i can get a custom made pipe
motopunk:
i used the original k5-radiators on my projekt... and all fits well in the ´93-steel-frame .
i think in first you should find out, how much you can lift up the left radiator for pipe-clearance.. and in the case that it works, weld on new rad-mountings to the frame...
post some pics, that we can see your major-problems.
Today we stand at the edge of the canyon, tomorrow we are one step further... :evil:... :-D
RKPerformance:
So i put the original pipe back on and ran it again. It runs like the choke is stuck on (but it is not). Im at a loss without being able to try a 500 pipe and silencer.
motopunk:
--- Quote from: RKPerformance on May 18, 2013, 06:14:21 AM ---So i put the original pipe back on and ran it again. It runs like the choke is stuck on (but it is not). Im at a loss without being able to try a 500 pipe and silencer.
--- End quote ---
:roll: :roll:... i repeat: post some pics, that the kawasaki-doctor can help with the right therapy for your sick bike... :wink:
sandblaster:
Men of steel can't read to good.
We like pics :-D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version