Maintenance & Technical > KX500 Original
Exhaust valve rail spacer,will a B.B work?
Motorrad:
they are easy to make.. I made usmc500's in a few minnutes.. (takes longer to put it in the lathe than it does to cut it)....
if there was more demand for em. Id do a run of them..
don46:
absolutely easy to make, he'd asked about the bb and I related my story, I think he said he found an oil drain plug that was configured correctly, that would be interesting, for those without a lathe to be able to run down to NAPA and buy this drain plug, everybody has a NAPA
Motorrad:
--- Quote from: don46 on April 05, 2013, 10:33:29 AM ---absolutely easy to make, he'd asked about the bb and I related my story, I think he said he found an oil drain plug that was configured correctly, that would be interesting, for those without a lathe to be able to run down to NAPA and buy this drain plug, everybody has a NAPA
--- End quote ---
+ 1 on the Napa thing.
SHLEPY:
--- Quote from: Motorrad on April 05, 2013, 10:18:34 AM ---they are easy to make.. I made usmc500's in a few minnutes.. (takes longer to put it in the lathe than it does to cut it)....
if there was more demand for em. Id do a run of them..
--- End quote ---
Ok weres mine :-D.
Motorrad:
--- Quote from: SHLEPY on April 05, 2013, 11:43:04 AM ---
--- Quote from: Motorrad on April 05, 2013, 10:18:34 AM ---they are easy to make.. I made usmc500's in a few minnutes.. (takes longer to put it in the lathe than it does to cut it)....
if there was more demand for em. Id do a run of them..
--- End quote ---
Ok weres mine :-D.
--- End quote ---
Ill get you a napa drain plug one.. with a magnet in it.... so the kips wont open. :lol: :lol:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version