Maintenance & Technical > KX500 Original
2 piece clutch cover
sandblaster:
--- Quote from: alward25 on March 05, 2013, 08:32:35 AM ---my boyeson cover i bought for my klx 450 had me remove the alignment pins. It seals fine without them.
--- End quote ---
Good to know.
Thanks!
sandblaster:
In fact, what I'm thinking about would look a lot like these:
alward25:
perfect!!!!!
sandblaster:
In the pictures it is at 1" thick.
It will be about 3/8" thinner then shown in an effort to keep the cover as close to the stock width as possible.
I have the preliminary blue prints at a machine shop to give me a quote on a production run of 10.
So at least we will have a rough idea...
sandblaster:
In the above pics the adapter is about 3/8" too thick.
Here is a better idea of how it will look.
I might be able to shave another 1/8" off the outer section but I need to do some checking first.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version