Maintenance & Technical > KX500 Original
2 piece clutch cover
sandblaster:
You are so right Roost ... I did some research last night and you are spot on.
Then again I would expect nothing else from you :-D
motopunk:
--- Quote from: sandblaster on March 20, 2014, 05:14:51 AM ---You are so right Roost ... I did some research last night and you are spot on.
Then again I would expect nothing else from you :-D
--- End quote ---
sympatic people, who sharing this knowledge are hard to find.. :-)... the big trick is, that it looks after welding and following processes like a non welded piece... 8-)
sandblaster:
Since my shop was broke into I have been really set back in all my projects.
The bike that I was using to test fit the two piece clutch cover on was stolen so I had to come up with another test fit method.
This should do nicely.
Junk case, junk trans shaft, and a junk clutch basket...
sandblaster:
After weld.
And does it fit?
Good!
sandblaster:
New bearings and seals... Install the inner clutch cover
Nothing binding...
Checking the clearance
Looks good with plenty of clearance 8-)
Looks like I might be able to take it for a test ride this week before I take it to the dunes.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version