Maintenance & Technical > KX500 Original
2 piece clutch cover
sandblaster:
I'd grab that one if I needed it.
That's a good buy.
motopunk:
--- Quote from: sandblaster on February 24, 2014, 11:09:50 AM ---
--- Quote from: motopunk on February 24, 2014, 05:13:10 AM --- its like finding a needle in a hay-barn ... but anywhere out there is the one, that i´m looking for. i feel it :-D
--- End quote ---
Just use a giant magnet or your x-ray vision... You'll find one :lol:
--- End quote ---
aluminium is not magnetic... :lol:
--- Quote from: tobys 2 strokes on February 25, 2014, 01:28:36 AM ---next thing is to find an good used 88/89 inner and outer clutch cover, when i have my bikes ready for the new season . its like finding a needle in a hay-barn ... but anywhere out there is the one, that i´m looking for. i feel it
if you wernt on the other side of our globe I would donate one to you. I have a fairly decant one I was saving to make one with, but have never gotten around to it but now am waiting for these to be on the market instead.
or this one looks better than mine
http://www.ebay.com/itm/Kx-250-clutch-outer-case-cover-and-water-pump-assembly-Fits-88-89-kx-250-/231166987957?pt=Motorcycles_Parts_Accessories&hash=item35d2a04eb5&vxp=mtr#ht_44wt_1022
--- End quote ---
the cover looks real good. ... but like you said its half around the globe and i have to watch out, that i´m not running out of my little amount of money for my other projects, when i buy parts all over the world for expensive shipping and customs clearance costs. usa was always the bigger market for bikes and parts as germany and europe and so it is always a little pokergame... :wink:
toby .. would you shoot me a pm with a pic of yours??
Snarf:
OK Sandblaster... let me me know where to send my parts and check! lol! that looks AWESOME!!
WOW!
sandblaster:
Made a little more progress today making a weld fixture to keep the adapter from warping during weld.
Next I'll have my buddy plasma cut the ID and trim up the OD.
Then I'll have him surface grind the side that sits against the adapter 8-)
cmotodad:
When I did my 2 piece, I just went for it. Welded it,ground it, cleaned it and installed it. No warpage or leaks. Seems like there is enough radiused edges to keep it flat.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version