Maintenance & Technical > KX500 Original
2 piece clutch cover
sandblaster:
The following pics are of a 89 kx250 clutch cover sitting on top of my cut down kx500 inner clutch cover.
sandblaster:
sandblaster:
Looking close at the pics, you can see that the 89 kx250 clutch cover is slightly smaller then the KX500 inner clutch cover.
motopunk:
--- Quote from: sandblaster on February 10, 2014, 11:15:39 AM ---
Looking close at the pics, you can see that the 89 kx250 clutch cover is slightly smaller then the KX500 inner clutch cover.
--- End quote ---
thats why the outer diameter of the clutch housing is a little bit cone formed on k5 and kx250 . but this diference is peanuts against the cover that you used before.. :wink:
this pic shows real good what i said and will try to make if i have the time and right material in hand.
now all can see , if it would be finished in this way it looks like it came from kawasaki-factory ... 8-)
and also no clearance-problem that would come with kickstarter or brake-lever by using an bigger diametered cover of an other engine.
sandblaster:
Well.... Get it done... I can't wait to see it :-D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version