Maintenance & Technical > KX500 Original
2 piece clutch cover
cmotodad:
You are right. I have spent many hours working on this cover. I am doing it with a small mill I have in the garage. If I were to do it again, I would weld some round stock on the milled case a to match an existing cover. Right now I have a big pile of alu.shavings and a sore back.
Enginerd:
--- Quote from: sandblaster on February 24, 2013, 09:08:29 AM ---I didn't want to say anything earlier, but I am going to start making one this week as time allows.
--- End quote ---
Way to go Mike! I hope you can get it done! I'd love to have one!
teambft:
How's this comin along?
sandblaster:
Other then drooling I haven't even made it to the shop yet.
I probably won't get started today as Monday's are incredibly busy...
alward25:
--- Quote from: sandblaster on February 24, 2013, 07:22:05 PM ---If someone has access to a CMM it would certainly speed up the process of making the model :-)
Doing it by hand would take quite an investment in time :-(
--- End quote ---
And I do........
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version