Maintenance & Technical > KX500 Original

Water Pump Drive Gear Snapped Off Crankshaft!

<< < (6/6)

don46:
I suggest you go back to page one and look at the pictures, there is NO bolt

alward25:
So, u need a crank half???

Polar-Bus:
OK, still had no idea what I was looking at until I looked at my manual. Didn't know Kawi used a primary gear retained by a circlip rather than a bolt on the 500. There is nothing in the manual about installing or removing the wp drive gear, however you can buy it as a separate part. I suggest buying a new wp gear as now your machinist will have a shaft reference dia. to measure when machining out the old shaft.

Navigation

[0] Message Index

[*] Previous page