Maintenance & Technical > KX500 Original

Ignition Wiring

<< < (2/4) > >>

LundMx:
I just saw your post on it.. I have a cheap ohm tester with not a whole lot of settings avalable. I am not a good electrical person at all!

motopunk:
I once had the same problem. first check the both black wires (black with white line on it), coming out of the cdi. One goes to the kill switch, the other to the stator. if you connect it wrong there is no spark. if you connect it properly, the spark is back.  :-)
then i made several connections to the wires, so I never connect it wrong again.  also make sure that the kill switch works properly.
good luck..

LundMx:

--- Quote from: motopunk on April 14, 2013, 08:19:46 PM ---I once had the same problem. first check the both black wires (black with white line on it), coming out of the cdi. One goes to the kill switch, the other to the stator. if you connect it wrong there is no spark. if you connect it properly, the spark is back.  :-)
then i made several connections to the wires, so I never connect it wrong again.  also make sure that the kill switch works properly.
good luck..

--- End quote ---

Now i heard from sandblaster that the two wires that come out of the cdi with the white stripes go to the same place in the cdi... Now im confused

Goat:
Danger sorry if this is against the rules. Delete if necessary. Just thought it would be easier than trying to explain it.

This is the 89 K5 wiring diagram. Hope this helps.

LundMx:
thanks! that helps

Navigation

[0] Message Index

[#] Next page

[*] Previous page