Maintenance & Technical > KX500 Original

well nuts spins in the subframe

<< < (2/2)

dieselbeef:
well i hated to do it but i started to drill the head off so i figured it would push in. i had a new nut but it wouldnt lock in ...got one from the local shop...so i had to drill the top off of it..now there is 2 of em inside the subframe..i drilled thru the backside and put a nut on it...pita but at least its one i can get to...

Seneca Jim:
I used JB weld to stop a couple of mine from spinning and it worked good. I also bought some from rocky mountain ATV but haven't gotten the tool yet.

don46:
usually, once they spin the hole gets oversized and a new one won't crimp in so you have to weld up the hole and redrill, then install the rev nut. I got my tool at Mcmaster Carr

Navigation

[0] Message Index

[*] Previous page