Maintenance & Technical > KX500 Original

kx 500 1983 restoration

<< < (2/3) > >>

kwakman:
I have an 83/84 microfiche if its any good to you? Where are you located? K.

Hesford:
Located in warrington near manchester.
  i use a microfiche on a site called cmsnl. i dont fully trust the microfiche though;     allballs didnt do a suspension linkage bearing kit for the 1983 but they did for a 1984. i checked the microfiche and the bearing part numbers were the same for both years - so i presumed 83 and 84 linkage bearings were the same. However the 84 bearings are 2mm smaller in diameter!!
 
  Does anyone know if a kx250 airbox is the same as the 500? found one for ?50.00 but not sure if it will fit. it also has extra air holes drilled in it.

kwakman:
pm me your address, you do mean uk dont you? I'll post you that fiche.K.

kwakman:
http://kawasaki.com/DefaultFrame.aspx?strContentUrl=/SITE/VIVEHICLEINFORMATION/VICHOOSEVEHICLE.ASP

fill yer boots....K

eddy:
Go to partpitstop.com; their website has exploded drawings and part numbers going back to 1966 Kawasakis.

Navigation

[0] Message Index

[#] Next page

[*] Previous page